Ampeg V4.com

forum

You are not logged in.

#1 2007-08-02 16:02:48

b0ne
Administrator
From: Portland, OR
Registered: 2005-12-19
Posts: 23

Amphead - Portland, OR

Jim Taylor has been my Ampeg repair guy for a few years now. I highly recommend him!

     Jim Taylor
     Amphead
     www.amphead.org

~tom
ampegv4.com

Offline

 

#2 2008-01-31 12:46:40

adangerlg
New member
Registered: 2007-08-30
Posts: 6

Re: Amphead - Portland, OR

I will recommend him also.  He's worked on a couple of my amps including my V-2 and his work is high quality at a very reasonable price.

Offline

 

#3 2018-02-28 10:13:30

Tony
New member
Registered: 2018-02-27
Posts: 8

Re: Amphead - Portland, OR

Hope someone can help me. I live in northern BC and there are no Ampeg repair shops anywhere near my city. I have converted the VT-22 V4 to EL34's on two circuits. I am using only two EL34's now (one on each transformer side. I have added the 1k ohm 10 watt grid screen resistors. (I will change them to 5 watt resistors when they arrive), set bias at 29ma each tube.

My question is... when I watch the bias current meters, (a seperate meter monitoring plate current on each of the two tubes) both on idle at 29ma each (545vdc), when playing at low to medium volume, bias seems fine (current fluctuates properly). But when I play loud, (more volume) the bias currents become unbalanced.

Watching both meters, one will fluctuate between 29 to about 95ma while the other fluctuates from 29 past 200ma. I have swapped and changed tubes of different manufacturers and it is definitely the same side of the transformer and not the tubes themselves. I had verified the meters also. I have checked the component values and all are fine, within <5% values.

Then, when I convert back to the 7027A's, re-adjusting the bias (using the other un-modded two tube circuits)the grid currents on both tubes are equal, both reaching together from 29ma to 95ma.

It does not matter which "balanced" EL34's I use, the same side of the transformer current value always excede the other by at least double.

I am using the appropriate speaker output impedance. Two tubes, 4 ohm switch setting for 8 ohm speaker load.

Anyone know what is going on?

Best regards,
Tony

Offline

 

Board footer

Powered by PunBB
© Copyright 2002–2005 Rickard Andersson