Help keep AmpegV4.com alive!
forum
You are not logged in.
#1 2014-04-21 18:40:07
- oldsoul
- Member
- From: Long Island, NY
- Registered: 2014-03-17
- Posts: 12
VT-40 Bias ?
Has anyone ever installed a bias pot for this amp? If not do you simply adjust at R215 which on the schematic is a 22K 1/2W 5%. If yes any insight on how best to install?
Offline
#2 2014-04-22 02:15:54
- hangman
- Banned
- From: Seattle Washington
- Registered: 2006-09-04
- Posts: 1848
Re: VT-40 Bias ?
if you install a bias pot... I wouldn't set it any higher than they did... unless your are using KT-88s
Offline
#3 2014-04-22 16:15:01
- oldsoul
- Member
- From: Long Island, NY
- Registered: 2014-03-17
- Posts: 12
Re: VT-40 Bias ?
I'm using 7027A's I was simply looking to make the bias adjustment a little easier with the pot. My question about which point of adjustment used is regarding whether you adjust individual resistors (R213, R214) going to the grids to compensate for slight mismatches or at a single point R215
Offline