Ampeg V4.com

forum

You are not logged in.

#1 2012-07-05 21:31:35

luthierwnc
Member
From: Asheville, NC
Registered: 2008-11-08
Posts: 18

replacement couplers for a Gemini II

Hi All,

I'm rebuilding a basket-case G15.  The guts look OK but I'd really rather not have to replace one component at a time.  In sketching the layout I also ran across some caps and resistors that were badly out of spec so the plan is to shotgun the board with all new components and take my chances that way.  The couplers are mostly WIMAs and green Cornell Dubiliers (the .047s at any rate).  The resistors are standard Ampeg issue for all the late '60's amps I've seen.

If you have some good ideas on replacements that sound close to the originals, I'd love to hear them.  On my own I'd probably go with polys and Vishay/Dale CCF60s for the standard-duty resistors.  Metal oxides for the power section.

Thanks for looking, Skip

Offline

 

Board footer

Powered by PunBB
© Copyright 2002–2005 Rickard Andersson