forum
You are not logged in.
#1 2007-09-22 00:34:20
- hangman
- Banned
- From: Seattle Washington
- Registered: 2006-09-04
- Posts: 1848
Ampeg Repair in Seattle
I repair Ampegs and other tube amplifiers in Seattle.
I'm a VT-22 and Gemini 1 owner and have worked on many V-4s, reverberockets, Portaflex, and SVTs. in addition to many other old Tube amplifiers.
Give me a call @ 360-789-9497, or email me.
Thanks,
Steve Wilson
Offline
#2 2012-10-15 16:22:22
- Andrew
- New member
- Registered: 2012-10-15
- Posts: 1
Re: Ampeg Repair in Seattle
Some online companies offer the most comprehensive source of parts for the restoration and repair of both vintage and modern Ampeg amplifiers. you can make your trip safe by motorhome hire. They also offer a full line of services including: amplifier repair, speaker repair and re-coning, cabinet refurbishment, and custom cabinets. get your own luxury motorhome hire. People will also find that this site is chock full of useful information to help with your selections. please have look at our motorhomes for hire
Last edited by Andrew (2012-10-28 01:14:24)
Offline
#3 2018-02-28 18:09:27
- Tony
- New member
- Registered: 2018-02-27
- Posts: 8
Re: Ampeg Repair in Seattle
Hope someone can help me. I have converted the VT-22 V4 to EL34's on two circuits. I am using only two EL34's now (one on each transformer side. I have added the 1k ohm 10 watt grid screen resistors. (I will change them to 5 watt resistors when they arrive), set bias at 29ma each tube.
My question is... when I watch the bias current meters, (a seperate meter monitoring plate current on each of the two tubes) both on idle at 29ma each (545vdc), when playing at low to medium volume, bias seems fine (current fluctuates properly). But when I play loud, (more volume) the bias currents become unbalanced.
Watching both meters, one will fluctuate between 29 to about 95ma while the other fluctuates from 29 past 200ma. I have swapped and changed tubes of different manufacturers and it is definitely the same side of the transformer and not the tubes themselves. I had verified the meters also. I have checked the component values and all are fine, within <5% values.
Then, when I convert back to the 7027A's, re-adjusting the bias (using the other un-modded two tube circuits)the grid currents on both tubes are equal, both reaching together from 29ma to 95ma.
It does not matter which "balanced" EL34's I use, the same side of the transformer current value always excede the other by at least double.
I am using the appropriate speaker output impedance. Two tubes, 4 ohm switch setting for 8 ohm speaker load.
Anyone know what is going on?
Best regards,
Tony
Offline